[TenTec] Help with FSK with an Orion II

[Dan Thompson]

Set Mark High.

73, Dan W4UH

-----Original Message-----
From: TenTec [mailto:tentec-bounces at contesting.com] On Behalf Of k2ep
Sent: Sunday, December 09, 2012 8:36 PM
To: Discussion of Ten-Tec Equipment
Subject: [TenTec] Help with FSK with an Orion II

I am trying to use my O2 on fsk.  Unfortunately the manual gives very little
info. on this mode.  When receiving in fsk mode I must adjust my pbt to
about -1800 to get readable signal.  It decodes fine then.  Is this normal?
Is there some where I can get more info. on operating fsk?  The keying sound
ok on the monitor.  Mark is set low.  Are their any other setting I need to
check?  I'm using a Rigblaster Advantage and mmtty s/w.  Any help would be
appreciated.

Tnx,  Ernie K2EP
_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec