[TenTec] Help with FSK with an Orion II

[Rsoifer at aol.com]

In a message dated 12/10/2012 4:35:50 PM GMT Standard Time, 
k2ep at nycap.rr.com writes:


> 
> I am trying to use my O2 on fsk.  Unfortunately the manual gives very 
> little info. on this mode.  When receiving in fsk mode I must adjust my pbt to 
> about -1800 to get readable signal.  It decodes fine then.  Is this normal? 
>  Is there some where I can get more info. on operating fsk?  The keying 
> sound ok on the monitor.  Mark is set low.  Are their any other setting I 

Ernie,

Rightly or wrongly, I have Mark set to High and PBT to zero.  In MMTTY, 
Mark is 2125 and  Shift is 170.  Tx Port under Misc is set to Com-TxD(FSK)..  
All I know is that it works.

73 Ray W2RS