[TenTec] OMNI D ser B low power output--still no joy

[Mike Bryce]

Scott, that T voltage is okay

do you have the tD voltage on low level driver? Should be about 4.5 volts or so


mike

On Feb 11, 2012, at 4:01 PM, scottsheppard at videotron.ca wrote:

> well, I have replaced all diodes save the zenor, the small signal transistors have also been replaced with 2n3904's and I have bypassed the PA all together...have virtually no output---maybe something in teh QRPp range...hardly moves needle at all on the SWR (Fwd) pos...
> 
> I do note my 'T' voltage is only 9.4 as opposed to 10.4...my meter may be off a bit but thats over a volt...can the T voltage be adjusted?
> 
> Sincerely appreciate all the input I have rec'd...
> scott
> 
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>