[TenTec] OMNI D ser B low power output--still no joy

[scottsheppard at videotron.ca]

The power supply is a 32 amp switching supply...meter on the amp is pretty steady at 13.8 but note my digital meter is a bit off...perhaps by a half volt or so.

given that the LLD is now connected essentially to the output of the rig bypassing the PA completely, it would seem the LLD is not doing its thing..yet, I have replaced pretty much all I could and no change...unless its some stupid little resistor or something...

It would seem to me that if I was getting up to 2-4 watts out with the PA on and tweaked, it was doing something...but only serving to amplify what little it rec from the LLD (or previous stage)...the stage before the LLD is the TX mixer...what power level should be generated out of it?

Time to get trained up on the osc that hase been sitting around collecting dust!

scott