[TenTec] RX366 9mHz output...

[Carl Moreschi]

You are correct but VE7TK's mod works much better with far less problems 
since you are using the main receiver's IF output.

Carl Moreschi N4PY
121 Little Bell Dr.
Hays, NC 28635
www.n4py.com

On 6/5/2012 7:01 PM, cx7tt at 4email.net wrote:
> Reading this thread leads me to believe that the RX366 board has a
> direct to the spare port on back of O II the 9mHz needed to run the P3
> panadaptor. Is this correct or is the VE7's mod still needed to do this?
>
> 73
> Tom
> CX7TT
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>