[TenTec] 960/961/962 power supply output connectors

[Wade Staggs]

*I have never done that but, can't see any problems with doing the mod. It
could decrease the resale value by not being original. Just remember the
Ten Tec Protection Circuit. As you probably already know, any attempt to
draw over 20 Amps should cause this fine power supply to shut down. My
friend Bill, has Anderson Power Poles mounted in the back of his 962 PSU.
Maybe I am too Old School but, just can't see what is so Magical about
Anderson Power Poles. The only thing that I can figure is that EmComm is
using them as a standard of some sort. My only suggestion would be to keep
the original Integrated Cable and just add your binding posts. This lets
you keep the PSU ... Ten Tec ready... This is the route that my friend Bill
took. *
*
73 cul de Wade/KJ4WS*

On Sun, Nov 4, 2012 at 7:02 AM, Barry N1EU <barry.n1eu at gmail.com> wrote:

> This might be a heretical question, but has anyone ever modified a
> 960/961/962 power supply and mounted heavy duty binding posts on the
> rear for the d.c. output, removing the integrated cable?
>
> 73,
> Barry N1EU
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>