[TenTec] Omni VI Logic board

[Mike Bryce]

just wondering,

what was the reason, if any, that Ten Tec sent the radio back as un-repairable?

lighting hit?

can of pop spilled inside?

Joe ham and his new soldering gun had a try?

just wondering....

mike, wb8vge



On Sep 3, 2012, at 9:55 AM, chacuff wrote:

> Thanks Clayton,
> 
> He was on my list of folks to contact since he was involved in the discussions a year or so ago.
> 
> Not sure if he will want to share too much of the secrets he might have discovered....:-)
> 
> Cecil
> K5DL
> 
> ----- Original Message ----- From: "Clayton Brantley" <clayton_n4ev at yahoo.com>
> To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
> Sent: Monday, September 03, 2012 7:41 AM
> Subject: Re: [TenTec] Omni VI Logic board
> 
> 
> Cecil: There is a guy near Greenville, SC that works on those things among other radios.
> You might try an email to glenn at dsmlabs.com and see what he says. He does have a
> 
> few of the Omni rigs for test jigs.
> 
> 
> 73 Clayton N4EV
> 
> 
> 
>