[TenTec] OT: Openwire/Window Line and Bad Wx

[k6jek]

Thanks

On Aug 3, 2013, at 2:04 PM, Steve Hunt wrote:

> Run any FF 3D plot and look at the Average Gain figure; it will tell you what fraction of the total input power is reaching the Far Field. If you set the wire losses to zero, you'll be left with just ground losses. AG is an efficiency figure, so 1-AG is the loss figure.
> 
> Steve G3TXQ
> 
> 
> 
> 
> 
> On 03/08/2013 21:51, k6jek wrote:
>> Steve,
>> 
>> Where are you getting losses out of EZNEC? I did re-run the the dipole at 25 and 55. As expected, all sorts of things are different. But where are you reading losses?
>> 
>> Jon
>> 
>> 
> 
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec