[TenTec] Transmit not stopping when PTT is released

[Dave Edwards]

Yea...back the power on the rig down to nothing, and see what happens!
....Dave



On 12/5/2013 5:51 PM, Carl Moreschi wrote:
> Sounds like an RFI problem to me.
>
> Carl Moreschi N4PY
> 58 Hogwood Rd
> Louisburg, NC 27549
> www.n4py.com
>
> On 12/5/2013 5:43 PM, Rod Greene wrote:
>> I just installed a new to me microKeyer II.  Trying to follow the 
>> setup instructions in the manual, I connected a mono cable (RCA 
>> plugs) between Amp Key 1 on the O2 and PTT IN on the mK2. When the O2 
>> is keyed (via footswitch or VOX) the O2 stays in transmit when the 
>> foot switch is released. Only way to get the O2 out of transmit is to 
>> turn its power switch off.
>>
>> Is this controlled by a setting I may have missed? I've read through 
>> the manual until I'm blue in the face ... As long as I don't connect 
>> this cable between Amp Key 1 and PTT IN everything seems to work okay.
>>
>>
>> Also - running the rig into a dummy load to eliminate RFI in the 
>> shack doesn't make any difference.
>>
>> For now I'll just not connect this cable. Not sure I need it, but 
>> haven't yet tried the mK2 with N1MM or any other software.
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>