[TenTec] Yamaha CM500, thanks

[Phil Sikes]

Thanks for all the input, I am using the battery box now but do not like the
idea of using batteries if the voltage is readily available at the mike jack
as it is. I did set the mike gain down to 0dB and that make it useable, just
a lot further from my face than I am used to and a little concerned about
external noises getting into my signal path. I normally ran my Ten Tec Heil
mike at 2.5 dB of gain so if I can get the CM500 padded so it will run in
that area it would make it much easier to swap them out. 
 
73 - Phil, N7UX
 
"LIFE IS NOT A JOURNEY TO THE GRAVE WITH THE INTENTION OF ARRIVING SAFELY IN
A PRETTY AND WELL PRESERVED BODY, BUT RATHER TO SKID IN BROADSIDE,
THOROUGHLY USED UP, TOTALLY WORN OUT, AND LOUDLY PROCLAIMING----WOW----WHAT
A RIDE!!!"