[TenTec] Need 962 diagram

[Bob McGraw - K4TAX]

Correction on my part.  As I had a 962 to repair this evening, I remembered 
that procedure I had given is for the 961 power supply where the filter is 
mounted on a angle bracket.  The 962 has the filters on a PC board.  Do make 
sure the screws are tight where the PC board is mounted.  Also check to see 
that the screws are tight holding the power transformer.

In my case the bridge rectifier was shorted thus immediately blowing a fuse 
on power up.   Replaced the bridge and all was well.  Took about 10 minutes 
to get it out and put in a new one.

73
Bob, K4TAX



.
----- Original Message ----- 
From: "Bob McGraw - K4TAX" <RMcGraw at Blomand.net>
To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
Sent: Wednesday, March 13, 2013 7:43 PM
Subject: Re: [TenTec] Need 962 diagram


> Be sure and tighten the two screws on the large filter cap and be sure the 
> metal bracket holding the filter cap is secure to the chassis.  I've found 
> that the metal bracket is often somewhat floating above ground.  The 
> result is the problem you describe.
>
> 73
> Bob, K4TAX
>
>
> ----- Original Message ----- 
> From: "John Farler" <k4avx1 at windstream.net>
> To: <tentec at contesting.com>
> Sent: Wednesday, March 13, 2013 6:55 PM
> Subject: [TenTec] Need 962 diagram
>
>
>>I have a TT 962 power supply that came with the Omni 6+.
>> It has an 24v ac component on the output that I believe indicates
>> the filter caps are bad or perhaps the full wave rectifier.
>>
>> Anyway, I have no diagram of the circuitry and am hoping some
>> one can scan and mail a copy or the whole manual, if someone
>> has it in pdf format. The manual for the power supply is not on
>> on the Ten-Tec old manuals page.
>>
>> Thanks in advance.
>>
>> John, K4AVX
>> k4avx1 at windstream.net
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>