[TenTec] High current

[denton]

..or a relay on the low pass filter board is getting a little flakey in the 
Omni...
That's very similar to what my Omni 7 was doing on 12 and 10 
meters..intermittent relay failure.
Finally the relay failed and the rig got sent to TT for repair.

--------------------------------------------------
From: "Richards" <jruing at ameritech.net>
Sent: Wednesday, March 13, 2013 8:25 PM
To: <n4py3 at earthlink.net>; "Discussion of Ten-Tec Equipment" 
<tentec at contesting.com>
Subject: Re: [TenTec] High current

> Right.
>
> Check your whole setup.  Check the antenna; the connections (are they free 
> from shorts and have good continuity, and are they all snugged up; check 
> your microphone and other connectors; check the SWR on the antenna system; 
> and all accessories in line.  Something is wrong, and this is the last 
> clue you get before the Omni VII shuts down.
>
>
>      ----------------  K8JHR ---------------------
>
>
>
>
> On 3/13/2013 10:21 PM, Carl Moreschi wrote:
>
>> It means that your current in the finals is very near the point where
>> the radio will shut down.
>
>
> _____________________________________________________________
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>