[TenTec] Orion 565 no audio or transmit

[John Huffman]

Barry -

Yes, a few times.  I'll work on the connectors first.  Thanks for the help.

73 de K1ESE
John


On 5/15/2013 5:08 PM, Barry N1EU wrote:
> Before you break out the tools or packing tape, have you first tried a
> Master Reset, RAM Clear or re-flash of the firmware?
>
> 73, Barry N1EU
>
> On Wed, May 15, 2013 at 8:14 PM, Carl Moreschi <n4py3 at earthlink.net> wrote:
>> Pull the front panel and spray all the cable connectors.  Unplug each
>> connector, spray them, and then plug them back in and out at least 10 times
>> to clean them.  There's at least 100 connections in there, each one with its
>> own symptom.  That fixed mine when I had an intermittent problem.  The fact
>> that the problem is intermittent points to a cable connection.
>>
>> Carl Moreschi N4PY
>> 121 Little Bell Dr.
>> Hays, NC 28635
>> www.n4py.com
>>
>>
>> On 5/15/2013 3:36 PM, John Huffman wrote:
>>> The last two days I have had an intermittent problem with my Orion 565.
>>> I have no receive audio or just white noise. When this happens no
>>> transmit output over 1 watt. Screen shows proper tuning and mode
>>> selections, but you can't hear anything or only hear white noise.
>>>
>>> Any ideas before I send it in?
>>>
>>> 73 de K1ESE
>>> John
>>>
>>> _______________________________________________
>>> TenTec mailing list
>>> TenTec at contesting.com
>>> http://lists.contesting.com/mailman/listinfo/tentec
>>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>