[TenTec] Orion 565 no audio or transmit

[Barry N1EU]

Before you break out the tools or packing tape, have you first tried a
Master Reset, RAM Clear or re-flash of the firmware?

73, Barry N1EU

On Wed, May 15, 2013 at 8:14 PM, Carl Moreschi <n4py3 at earthlink.net> wrote:
> Pull the front panel and spray all the cable connectors.  Unplug each
> connector, spray them, and then plug them back in and out at least 10 times
> to clean them.  There's at least 100 connections in there, each one with its
> own symptom.  That fixed mine when I had an intermittent problem.  The fact
> that the problem is intermittent points to a cable connection.
>
> Carl Moreschi N4PY
> 121 Little Bell Dr.
> Hays, NC 28635
> www.n4py.com
>
>
> On 5/15/2013 3:36 PM, John Huffman wrote:
>>
>> The last two days I have had an intermittent problem with my Orion 565.
>> I have no receive audio or just white noise. When this happens no
>> transmit output over 1 watt. Screen shows proper tuning and mode
>> selections, but you can't hear anything or only hear white noise.
>>
>> Any ideas before I send it in?
>>
>> 73 de K1ESE
>> John
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec