[TenTec] Triton IV 540 Questions

Mike Bryce prosolar at sssnet.com
Fri Apr 18 12:42:23 EDT 2014


Wes,

1. You need to replace the elastic string on the dial. that’s why it’s dropping at the low end.

2. Calibrator should be balls to walls strong. check the rec/trans switch on the rear. Operate it a few times. Pop the cover and make sure the calibrator is there. Easy to find, look for the large long crystal 

3. That is normal. The PTO shaft is above ground and touching the dial skirt will cause a shift in freq. there are a few simple fixes for this or you can do what Ten Tec tells you to do. “Don’t touch the dial skirt”

4. Got me on the last one.


Mike Bryce wb8vge
prosolar at sssnet.com



On Apr 17, 2014, at 8:10 PM, wes bolin <k5apl41 at gmail.com> wrote:

> I just acquired a Triton IV and 252G Power Supply.  I have a couple of
> problems with it (1)  Dial does not travel all the way to the left.  It
> hangs up/stops but tuning
> of PTO continues ok.  Need new string?
> (2)  No Calibrator signal....maybe very very weak. Any suspects?   (3)
> Slight tendency of PTO to shift 100Hz when taking finger off plastic part
> of the knob.
> PTO Rebuild Kit needed?
> It came with a frequency counter but I don't think it is Ten Tec.  Its all
> red LEDs
> and no markings whatsoever.  Two parallel 10 ohm resistors on back panel
> that
> are 5W or so and they do get hot.  It seems to work well.  Does it sound
> familiar?
> 
> Thanks for letting me ask these questions.  I am just getting back into Ham
> Radio after about a 5 year absence. Owned some Ten Tec in the past so I
> picked up
> this radio and really would like to make it work well.
> Wes
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 



More information about the TenTec mailing list