[TenTec] OMNI D question

[Al Gulseth]

"Back when" I had surprisingly good success with cheapie Hi-Z dynamic mics 
designed for 11 meter rigs ;)  Another possibility (which requires building 
an adapter to enable PTT) would be one of the older Radio Shack dynamic PA 
mics which can be set for 50K impedance. I've used both types and always 
received good audio reports.

73, Al


On Sun August 17 2014 9:27:11 pm Louis Ciotti wrote:
> Not to thread jump, but any recommendatioins on a decent low cost hand mic
> for use with the older TenTec rigs?
>
> On Sun, Aug 17, 2014 at 9:44 PM, Al Gulseth <wb5jnc at centurytel.net> wrote:
> > From the Ten-Tec Wiki: "Microphone Impedance: High impedance crystal,
> > ceramic,
> > or dynamic." (This applies to all the older TT rigs with a 1/4" phone
> > jack for the mic connector.)
> >
> > 73, Al
> >
> > On Sun August 17 2014 8:22:21 pm Alexander N. Gerli wrote:
> > > Is the OMNI-D mic input Hi- or Lo-Z?
> > >
> > > ​73,​
> > >
> > >
> > > ​Sandy AC1Y​
> > >
> > >
> > > Alexander N. Gerli, Sr.
> > > 548 Allred Mill Road
> > > Mount Airy, NC 27030-2202
> > >
> > > Scotsmen walk about 900 miles each year.
> > > A Scotsman drinks around 45 gallons of Whisky a year.
> > > Scotsmen get about 20 Miles Per Gallon.
> > > _______________________________________________
> > > TenTec mailing list
> > > TenTec at contesting.com
> > > http://lists.contesting.com/mailman/listinfo/tentec
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec at contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec