[TenTec] 9 MHz tap on EAGLE... and then.....

[Carl Moreschi]

HDSDR works well with Ensemble II.  My N4PY software will marry the 
Eagle and HDSDR.

Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
www.n4py.com

On 12/28/2014 9:16 AM, Barry N1EU wrote:
> It sounds like someone tapped the 9MHz i.f. and ran it out through a
> Clifton Labs buffer amp.  This is a user applied mod.
>
> Barry N1EU
>
> On Sun, Dec 28, 2014 at 1:43 PM, David Perrin<dbperrin at gmail.com>  wrote:
>
>>          Reading what had been posted on the topic of locating a 9 MHz tap
>> on an older EAGLE I opened up my EAGLE to investigate.  What I found on the
>> left side of the rig was a small pc board mounted by one screw on a
>> vertically positioned shield. There are two mini-coax cables running to it.
>>          As you look at the board (mounted) I soldered a mini coax cable to
>> the “top” coax connector. Then I was able to run that coax along that
>> shield for the length of that pcbd and towards the rear panel. A small hole
>> was drilled in the rear panel to feed that coax out the rear. I took a few
>> pictures if you’re interested- email me.
>>          In a related issue, my problem now is to get  software to work
>> with it. After loading the Ensemble II software it keys me to use the
>> easier fast load of the required files. I haven’t been able to bring up the
>> DAQ file for the Ensemble II once the loading program has been loaded, it
>> keeps reverting to an earlier file that was used a few years ago with the
>> Raocmite40 receiver.
>>          What software is proven to work with the Ensemble II?
>>
>> 73 de Dave, K1OPQ
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec