[TenTec] Corsair II. DSB generator alignment???manual issues

[Barry N1EU]

Connect probe to resistor junction and probe shield to chassis ground.
 Yes, 3KHz minus the cw sidetone offset (750hz).

Manual directions seemed okay to me - have done it many times.  Only
issue I've ran into is the trimmer caps age and might need replacing.
But they're still a stock item at Mouser and replacement is pretty
easy.

73, Barry N1EU

On Mon, Feb 17, 2014 at 3:16 PM, Scott Shepard
<scottsheppard at videotron.ca> wrote:
> Hey folks,
>
> Trying to align the double side band gen on my corsair to get the cw I ligament where it should be. I am having some difficulty with the what the manual is saying...
>
> ' connect the counter to the junction r3 and r4 in the emitter of Q1'
>
> Now, I know it should be r11 and r12' but what does 'in' mean?  Is it saying one lead to the junction of r12 and r13 and the other to the emitter...or, as I have, shielded lead of counter to chassis ground and the probe to the junction of the two resistors?
>
> Further, it says to adjust c1 for 9.00300 at SB-R.  And then, c2 at LOCK pos to to 9.000750
>
> That's 2.250 kc diff is it not?
>
> Anyway, maybe I am just tired but this seems more complicated than it ought to be :)
>
> 73
> Scott. Va3ied
>
> Sent from my iPad
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec