[TenTec] Does this happen to you on transmit...OMNI V ??
Carl Moreschi
n4py3 at earthlink.net
Mon Feb 24 17:33:55 EST 2014
Sounds like RF feedback. This can be a tough one to figure out.
Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
www.n4py.com
On 2/24/2014 5:29 PM, Scott Shepard wrote:
> I am going thru a variety of projects presently and am now at the omni V ...it seems on most bands above 80 m if I increase power to past 3/4 point the display blanks out and it gets stuck in tx mode...as though swamped with RF...I have the new chip 9.v2 ...I have to turn the rig off in order to reset the controls...any ideas or similar experience?
>
> Kind regards
>
> Scott VA3IED
>
> Sent from my iPad
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
More information about the TenTec
mailing list