[TenTec] Does this happen to you on transmit...OMNI V ??

[Mike Hyder -N4NT-]

What's your power supply?

----- Original Message ----- 
From: "Carl Moreschi" <n4py3 at earthlink.net>
To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
Sent: Monday, February 24, 2014 17:33
Subject: Re: [TenTec] Does this happen to you on transmit...OMNI V ??


> Sounds like RF feedback. This can be a tough one to figure out.
>
> Carl Moreschi N4PY
> 58 Hogwood Rd
> Louisburg, NC 27549
> www.n4py.com
>
> On 2/24/2014 5:29 PM, Scott Shepard wrote:
>> I am going  thru a variety of projects presently and am now at the omni V 
>> ...it seems on most bands above 80 m if I increase power to past 3/4 
>> point the display blanks out and it gets stuck in tx mode...as though 
>> swamped with RF...I have the new chip 9.v2 ...I have to turn the rig off 
>> in order to reset the controls...any ideas or similar experience?
>>
>> Kind regards
>>
>> Scott VA3IED