[TenTec] Invoking OM7 500 Hz filter ?

[bcarling at cfl.rr.com]

I keep telling myself it CAN'T be this hard to understand!
I figured out 99% of the operation of the OMNII VII easily by reading the manual. 
On this point however, it is clear as mud so far...

On 10 Jul 2014 at 19:17, Bob McGraw - K4TAX wrote:

> The filter automatically switches with the BW selection. Observe the display 
> at the left where you see "IF"  The selected filter is then shown to the 
> right of this label.  For this to happen, the MENU selection for I-F FILTER 
> must be set to AUTO.
> 
> Otherwise one can select the filter of their choice with the selection of 
> values at this line.
> 
> 73
> Bob, K4TAX
> 
> 
> ----- Original Message ----- 
> From: <bcarling at cfl.rr.com>
> To: <tentec at contesting.com>
> Sent: Thursday, July 10, 2014 6:42 PM
> Subject: [TenTec] Invoking OM7 500 Hz filter ?
> 
> 
> > Hello,
> >
> > I now have a clean sounding OMNI VII after doing a master reset. Thanks 
> > guys.
> >
> > Does anyone know how to invoke the 500 Hz Collins filter once it is 
> > installed and enabled?
> >
> > I have read the manual through twice and still can't figure out how to 
> > switch from 2.5 kHz
> > filter to 500 Hz !!  Maybe I am not too smart. The book seems to dance all 
> > around the topic
> > but never tell you how!
> >
> > 73 - Brian, AF4K
> >
> > Brian Carling, Radio AF4K
> > _______________________________________________
> > TenTec mailing list
> > TenTec at contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> > 
> 
>