[TenTec] Eagle problem?
Carter
k8vt at ameritech.net
Thu May 15 22:45:58 EDT 2014
On 5/15/2014 4:28 PM, Robert wrote:
> Correct. But with the Paragon series and Omni V & VI series, anytime you have a mike connected along with the back panel source too then you have both connected.
Absolutely true -- but I have never yet used the rear connector.
> Use the mike when needed but disconnect the rear pnl connection. Same when using the audio in on the rear, disconnect the mike.
>
> Again, bond all equipment together at the power supply and forget abt a dedicated external ground.
I can try removing the external ground. I currently have 3/4" wide
single piece of braid going from the radio to the PS to the amp to an
outside ground (total length from last unit in line to the hole in the
basement wall is less than 5 feet).
73,
Carter K8VT
More information about the TenTec
mailing list