[TenTec] Eagle problem?

[Bob McGraw - K4TAX]

Seems easy enought to do.   Certaily I'd operate without the external ground 
connected.  This being said presumes you have 3rd pin ground being used for 
the power supply and the amp.  If these are "lifted" then it is not 
adviseable to remove the other ground.  In any event, NEC requires 3rd pin 
ground to be in place.

Also, the external ground must be bonded outside of the structure to the AC 
mains ground.  This too per NEC.

73
Bob, K4TAX


----- Original Message ----- 
From: "Carter" <k8vt at ameritech.net>
To: <tentec at contesting.com>
Sent: Thursday, May 15, 2014 9:45 PM
Subject: Re: [TenTec] Eagle problem?


> On 5/15/2014 4:28 PM, Robert wrote:
>> Correct. But with the Paragon series and Omni V & VI series, anytime you 
>> have a mike connected along with the  back panel source too then you have 
>> both connected.
>
> Absolutely true -- but I have never yet used the rear connector.
>
>>    Use the mike when needed but disconnect the rear pnl connection. Same 
>> when using the audio in on the rear, disconnect the mike.
>>
>> Again, bond all equipment together at the power supply and forget abt a 
>> dedicated external ground.
> I can try removing the external ground. I currently have 3/4" wide single 
> piece of braid going from the radio to the PS to the amp to an outside 
> ground (total length from last unit in line to the hole in the basement 
> wall is less than 5 feet).
>
> 73,
> Carter   K8VT
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>