[TenTec] [Bulk] Re: OT: Holiday SDR Project

[Carl Moreschi]

Yes, for the Softrock, use HDSDR as the panadapter program.  All my 
software interfaces easily with HDSDR.

73,


Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
www.n4py.com

On 11/5/2014 8:27 PM, Bill Lathan wrote:
> Carl, what is required software for this SDR Project? I am using your
> software with an Eagle. Will it interface with the Smartrock hardware?
>
> Thanks,
>
> Bill, AK5K
>
> -----Original Message-----
> From: TenTec [mailto:tentec-bounces at contesting.com] On Behalf Of Carl
> Moreschi
> Sent: Wednesday, November 05, 2014 11:21 AM
> To: Don Rasmussen; Discussion of Ten-Tec Equipment
> Subject: [Bulk] Re: [TenTec] OT: Holiday SDR Project
>
> That will work well for you.  My N4PY software can provide everything you
> need to keep the softrock and your transceiver on the same frequency.
>
> Carl Moreschi N4PY
> 58 Hogwood Rd
> Louisburg, NC 27549
> www.n4py.com
>
> On 11/5/2014 11:34 AM, Don Rasmussen via TenTec wrote:
>> After all this talk about the new Flex Series and peripherals it seems all
> of my objections have melted away except for the oldest one - cost! Flex
> 6300 with FX-PAD and TMate2 are outside of my ham radio budget but only
> because I have that amount of money tied up in existing gear that I enjoy.
>>
>> I did decide to take a look at what Tony Parks has been up to and found a
> very inexpensive SDR project for the holidays. I can enjoy the build and
> then mess with the software. The 1.8-30Mhz receiver is $68 and the option
> cabinet is $20.
>>
>> http://tinyurl.com/qx4ha8p
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>