[TenTec] Fwd: Ten Tec OMNI VII question

[Carl Moreschi]

It is standard RS232 for a DB9. The female DB9 on the Omni VII pins are

pin 2 TX data  ( this is RX data on the PC side)
pin 3 RX data  ( this is TX data on the PC side)
pin 5 ground
pin 7 RTS
pin 8 CTS
pin 4 DTR
pin 6 DSR

The Omni VII requires RTS and CTS to be used.  It runs only at 57600 
baud 8 bit no parity.

Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
www.n4py.com

On 11/20/2014 8:01 AM, Ron Notarius W3WN wrote:
> If anyone can help KO7SS, please respond directly to him.  Thank you.
>
>
> -------- Original Message --------
> From: ko7ss at yahoo.com
> Date: Nov 19, 2014 11:37:54 PM
> Subject: Ten Tec OMNI VII question
> To: "w3wn at n3sh.org"
>
> Hi,
>
> I can't seem to join the Ten Tec reflector to ask a question, maybe you can
> post it? This info is not in the manual....
>
> I am trying to connect an OMNI VII serial port to an Expert Amps 2K-FA.
> Which of the pins on the OMNI VII serial port is the TX 232?
>
> Thanks, Bill Straw, KO7SS
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>