[TenTec] Omni V deaf and won't transmit on 20m
Stuart Rohre
rohre at arlut.utexas.edu
Thu Nov 20 16:34:42 EST 2014
Re-seat all plug in cables associated with the 20m section of the
receiver. Check tightness of any screws that serve to ground the ground
plane of the board. Inspect the bandswitch with a strong pen light and
see if there is obvious corrosion on the switch contacts at the 20m
setting. Rotate the switch vigorously from 20 to 40, and 20 to next
band higher if any doubt.
Many faults that come from a radio sitting unused for a band may lie in
the above possibilities.
GL,
Stuart
K5KVH
More information about the TenTec
mailing list