[TenTec] [Ten Tec} Corsair II weak weak receive

jon greenwood n8mus at yahoo.com
Wed Oct 21 21:09:54 EDT 2015


Success!!!! Steve you nailed it! I had no ground at R33 and C23. I took me a while to realize how ground made it to this point on the board. 
The ground runs through the case of L6. I traced back to there and still no ground. I picked up on L6 and the case popped right off in my hand. Both solder tabs were broken off. I did not have a spare so I ran a wire up and over L6. Soldered the wire in both pads and to the top of the case of L6 to ground it. Fired the rig up and was copying WWV on 10 MHZ with only a 6 ft coax pigtail attached. Hooked that up to an antenna and the Corsair is back in business! Did an alignment and comparing to my TS480 with it's preamp on The Corsair is neck and neck with it. Just a lot quieter! 
The voltages on Q6 are now R32/R33 1.6v the R31/32 11.0 and the emitter is .9v So the collector is still a little high but the other two are now at spec. and Q6 seems to be functioning great. The AGC was dead and is now working normally. 
So big THANK YOU to everyone for your input, especially Steve for pointing to the solution.73Jon N8MUS
 


     On Sunday, October 11, 2015 1:33 AM, Steve Hunt <steve at karinya.net> wrote:
   

 Jon,

One other check you might want to make while Q6 is removed: on Rx, 
measure the voltage at the R32/R33 junction, and the voltage at the 
R31/R32 junction; they should be around 1.7v and 9.5v respectively.

Steve G3TXQ


_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


   


More information about the TenTec mailing list