[TenTec] Ten tec OmniVI+

[rick@dj0ip.de]

First of all there is a jumper to move when using the CW filters because
they have a higher insertion loss than the SSB filters.  If you have not
moved the jumper, that might be a reason.

But, unfortunately there was a lot of deviation in the insertion loss of
filters and sometimes individual filters have 5 or 10 dB more loss than most
others.  In such cases you will probably find just one of the crystals is
bad, but easiest way is to replace the filter.

73 - Rick, DJ0IP
(Nr. Frankfurt, Germany)


On 7/13/2016 12:53 PM, William Hill wrote:
> My Omni VI+ loses a very significant amount of signal when either the 
> 500hz or 250 hz on the 6.3 mhz board are selected. Does anyone have a 
> suggestion what I should try to eliminate this condition?
> Bill/W3WH
> w3wh at comcast.net
>
> ---
> This email has been checked for viruses by Avast antivirus software.
> https://www.avast.com/antivirus
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec