[TenTec] Ten tec OmniVI+

[Bwana Bob]

Bill:

I had the same problem with the 500 Hz filter in my Paragon. Selectivity 
was fine but insertion loss was higher than the other filters. I swapped 
in the 500 Hz filter from my Corsair and it was fine. I thought of 
replacing all of the capacitors in the filter, but figured that the 
problem was more likely crystal aging. I didn't want to buy a used 
filter, which might have the same aging problem, so I opted for an INRAD 
500 Hz filter.  The new filter fixed the problem and it seems to have 
better skirt selectivity than the old Ten Tec filter.

73,

Bob WB2VUF


On 7/13/2016 12:53 PM, William Hill wrote:
> My Omni VI+ loses a very significant amount of signal when either the 
> 500hz or 250 hz on the 6.3 mhz board are selected. Does anyone have a 
> suggestion what I should try to eliminate this condition?
> Bill/W3WH
> w3wh at comcast.net
>
> ---
> This email has been checked for viruses by Avast antivirus software.
> https://www.avast.com/antivirus
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>


---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus