[TenTec] Paragon SN 382 Intermittent Receive Glitch

[Gary J FollettDukes HiFi]

I have a complete and fully functional relay board and output low pass filter board for a Paragon if anyone has a need.

Gary
> On Jun 4, 2016, at 10:41 AM, Bwana Bob <wb2vuf at verizon.net> wrote:
> 
> I've had relay problems with my Paragon that causes it to lose receive sensitivity.  Transmitting into a dummy load for a few seconds cures it for me.
> 
> 
> 73,
> 
> 
> Bob WB2VUF
> 
> 
> On 5/25/2016 3:04 PM, k7mks at comcast.net wrote:
>> My Paragon has an intermittent problem in receive where the S Meter reading decreases rapidly as does the volumn of whatever station I am tuned to regardless of band, frequency, or mode. The decrease is instantaneous and can be short lived and has been corrected a couple of times by tapping on the case. I suspect a poor/cold solder joint somewhere. At times it will receive for hours without a problem. I'm beginning to suspect that the First Mixer Board (#81331) may be the culprit and would welcome your thoughts
>> 
>> Thank you Joe k7mks
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>> 
> 
> 
> ---
> This email has been checked for viruses by Avast antivirus software.
> https://www.avast.com/antivirus
> 
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec