[TenTec] Paragon SN 382 Intermittent Receive Glitch

[Bwana Bob]

I've had relay problems with my Paragon that causes it to lose receive 
sensitivity.  Transmitting into a dummy load for a few seconds cures it 
for me.


73,


Bob WB2VUF


On 5/25/2016 3:04 PM, k7mks at comcast.net wrote:
> My Paragon has an intermittent problem in receive where the S Meter reading decreases rapidly as does the volumn of whatever station I am tuned to regardless of band, frequency, or mode. The decrease is instantaneous and can be short lived and has been corrected a couple of times by tapping on the case. I suspect a poor/cold solder joint somewhere. At times it will receive for hours without a problem. I'm beginning to suspect that the First Mixer Board (#81331) may be the culprit and would welcome your thoughts
>
> Thank you Joe k7mks
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>


---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus