[TenTec] Jupiter power problem

Fernando n2fq at sbcglobal.net
Thu Nov 3 16:05:34 EDT 2016


Hello.

I would make certain that the ground connection is still true.
RF getting into the rig will mimic this behavior.

I would also check the power connector, the fuse and fuse holder.

This was a reason that I did the Molex to Power Pole conversion

six years ago. No problem since.


Fernando N2FQ/6
n2fq at sbcglobal.net




> On Nov 3, 2016, at 11:53 AM, Louis C Loria via TenTec <tentec at contesting.com> wrote:
> 
> 
> My Jupiter has a problem where it will act as though there is a power surge when I hit the transmit button.
> 
> The screen on the Jupiter goes blank and I hear all the relays cycle and then  I have to recycle the on-off
> 
> switch and it comes back to life ok.  Sometimes it will go for a couple of days without doing this and then
> 
> it might do it two or three times in a day. Any ideas?
> 
> Louis C Loria, W0QQG
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec



More information about the TenTec mailing list