[TenTec] TX Audio Problems With Corsair II

[Steve Berg]

It works fine on cw, which is what I normally use.

Steve WA9JML


On 11/13/2016 5:57 PM, GARY HUBER wrote:
> You might check the diodes on the VSWR circuit board.
>
> 73 ES DX,
> Gary - AB9M
>
> On 11/13/2016 3:16 PM, Steve Berg wrote:
>> I fired up my Corsair II to check into the Ten Tec nets today. It
>> receives fine, but when I tried to transmit on SSB, the ALC light lit
>> up solidly, and it took backing way down on the drive level to make it
>> stop.  I haven't used it much this summer, but I had it on for about 5
>> hours before the net times.  Luckily, I was able to check in on the 20
>> meter net with my Argo VI barefoot.
>>
>> This is a new problem with the radio, so where might I start looking?
>>
>>
>> 73,
>>
>> Steve WA9JML
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>