[TenTec] CorsairII ALC LED

[Steve Ellington]

Barry. I just had a bout with one of my Corsair II's ALC LEDs. On the top
of the rig you'll find the Low Level Driver board toward the left rear.
There's a thumbwheel pot R15 that adjust the LED's firing point. The manual
gives the adjustment procedure on page 3-23

On Wed, Nov 23, 2016 at 3:59 PM, Barry N1EU <barry.n1eu at gmail.com> wrote:

> I've got a Corsair II that is transmitting fine with full power output.
> But it seems like the ALC LED is functioning intermittently.  Can anybody
> point me toward the source of the LED drive signal?
>
> Thanks & 73,
> Barry N1EU
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>