[TenTec] Omni D quits after 60-90 minutes

[Mike Bryce]

I’d suspect the “T” and “R” voltages and the switch over on the control board.
Check their levels. If they (or one) is between values i.e. +12 on rec is no +4, that could screw things up 

Mike, WB8VGE

“The trouble with quotes on the Internet is that you never  know if they are genuine”

—Abraham Lincoln

> On Apr 13, 2017, at 10:58 AM, Curt Benjamin via TenTec <tentec at contesting.com> wrote:
> 
> Tom, find out if there’s a signal missing when it quits – i.e. PTO or something. If it affects receive and transmit on all bands, I would say it’s not a pre-mix oscillator for one band,but something common. It also could be a DC voltage missing. I don’t have the manual in front of me to see what it could be – I’ll have to wait until I’m done with work. This seems like it would be a easy fix if you could think it through and take some measurements with the forum’s help if needed. 
> 
> Curt, K8AI
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec