[TenTec] jupiter low RF output on the higher bands
Bryan Lee Cornwell
blcornwell at k2blc.com
Mon Feb 6 17:08:19 EST 2017
Joe
It may be the relays on the low pass filter board for the upper
bands...pretty easy fix if that is the issue
73
Bryan K2BLC
On 2/6/2017 4:56 PM, Joe W2KJ wrote:
> Howdy Ten Tec’ers:
>
> A friend of mine has been trying, unsuccessfully so far, to get on the email reflector so I told him I would see if I could get a response to his problem.
>
> His Jupiter puts out 100W from 160M thru 20M….but the output gets progressively lower from 50W out on 17M to just a few watts on 10M.
>
> Is there something in common to those bands that could account for the low output seen?
>
> Is there a tune-upprocedure for the higher bands on the Jupiter?
>
> Could one of the finals be bad causing the drop on the higher bands?
>
> Any info/suggestions are most welcomed.
>
> Thanks in advance.
>
> 73, Joe W2KJ
>
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
--
Bryan Lee Cornwell
blcornwell at k2blc.com
http://k2blc.com
More information about the TenTec
mailing list