[TenTec] jupiter low RF output on the higher bands

[Carl Moreschi]

Sounds like a bad relay on the low pass filter board.

Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
www.n4py.com

On 2/6/2017 4:56 PM, Joe W2KJ wrote:
> Howdy Ten Tec’ers:
>
> A friend of mine has been trying, unsuccessfully so far, to get on the email reflector so I told him I would see if I could get a response to his problem.
>
> His Jupiter puts out 100W from 160M thru 20M….but the output gets progressively lower from 50W out on 17M to just a few watts on 10M.
>
> Is there something in common to those bands that could account for the low output seen?
>
> Is there a tune-upprocedure for the higher bands on the Jupiter?
>
> Could one of the finals be bad causing the drop on the higher bands?
>
> Any info/suggestions are most welcomed.
>
> Thanks in advance.
>
> 			73, Joe W2KJ
>
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec