[TenTec] Omni 6 LPF Board jumpers

Clayton Brantley clayton_n4ev at yahoo.com
Sun Feb 26 13:08:41 EST 2017


Gary:  I looked at my spare board and see no jumpers.  This is a 42837 rev c on one corner and 92837 rev d on the othercorner.  Your best guess!  HI.  On the top of the board it says 92837 rev c in two places along with 81593 near coax #17connector.  Oh, I was looking at the RONG board, The filter with relays also has no jumpers.  It's a 92835 rev e board.
Clayton


      From: Dukes HiFi <dukeshifi at comcast.net>
 To: Discussion of Ten-Tec Equipment <tentec at contesting.com> 
 Sent: Saturday, February 25, 2017 10:18 PM
 Subject: [TenTec] Omni 6 LPF Board jumpers
   
I bought an Omni 6 (older one) form someone recently. I had an issue on the LPF relay board and removed it for replacement of a relay and a series resistor.

However, I saw 5 jumpers that looked to be made from factory white wire common in the radio. These made a diagonal pass across the board and look as though they were intended to correct a PC board tapping error.

Has anyone else seen this?

The reason I need to know is that, thinking this was some sort of hack job by someone, I removed the jumpers and jumpers the cuts in the PC board where the jumpers were connected.

Now it occurs to me that this might have been a short term fix for a board design mistake and that I need to put it back the way it was, only I don’t exactly recall how it was prior to “correction”/

Any ideas?

I suppose I could just connect the board up, pass signals through it with a signal generator and see which relays/coils get selected by the CPU when bands are selected.

Dumb mistake on my part, maybe someone could offer some assistance.

Gary

W0DVN
_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


   


More information about the TenTec mailing list