[TenTec] Omni 6 LPF Board jumpers

Dukes HiFi dukeshifi at comcast.net
Sat Feb 25 22:18:51 EST 2017


I bought an Omni 6 (older one) form someone recently. I had an issue on the LPF relay board and removed it for replacement of a relay and a series resistor.

However, I saw 5 jumpers that looked to be made from factory white wire common in the radio. These made a diagonal pass across the board and look as though they were intended to correct a PC board tapping error.

Has anyone else seen this?

The reason I need to know is that, thinking this was some sort of hack job by someone, I removed the jumpers and jumpers the cuts in the PC board where the jumpers were connected.

Now it occurs to me that this might have been a short term fix for a board design mistake and that I need to put it back the way it was, only I don’t exactly recall how it was prior to “correction”/

Any ideas?

I suppose I could just connect the board up, pass signals through it with a signal generator and see which relays/coils get selected by the CPU when bands are selected.

Dumb mistake on my part, maybe someone could offer some assistance.

Gary

W0DVN


More information about the TenTec mailing list