[TenTec] OMNI 6 SWR shutdown
Harald Rester
harryrester at gmx.de
Wed May 17 13:13:00 EDT 2017
Doug,
I had the same problem. It turned out that the PA-board drawed to much
current (and further more the current increased rapidly), even with no
driver at all - Bias was ok and I suspect a fault in the finals.
Expecting my purchased pa-board soon...
73, Harry, DH1NBE
Am 16.05.2017 um 22:13 schrieb Doug Snowden:
> I have an OMNI 6+ that instantly shuts down when keying on CW with no
> output drive or on SSB with mike gain at zero. It is not an SWR
> issue. Any hints? Just put it on the bench to start looking at it.
> The manual describes the ALC circuit pretty well.
>
>
> Doug N4IJ
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
More information about the TenTec
mailing list