[TenTec] Orion II Display problem?

[Rod Greene]

Thanks Gary. I did replace the snaphat battery last year too. If the problem crops up again, I will try the hard reset.73, Rod/w7zrc
 

    On Monday, November 6, 2017, 3:20:11 PM MST, Dukes HiFi <dukeshifi at comcast.net> wrote:  
 
 Did you change your CPU battery?

Try that, then a hard reset.

See what transpires.

Gary


> On Nov 6, 2017, at 4:07 PM, Rod Greene via TenTec <tentec at contesting.com> wrote:
> 
> During SSCW I noticed (after a few hours of operating) the number 9 creeping in from the right side of the display. It never completely became visible, but was definitely there and in large font. Later on in the SS a third megahertz number appeared on top of the regular megahertz numbers for each VFO. I could correct this easily by turning the OII off and back on. I was using N1MM+ in SO2V mode. 
> Any thots on this or other similar experience? I have replaced the A9 board caps last year. And the display is working fine today.
> Thanks and 73, Rod/w7zrc
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec