[TenTec] Paragon 585 com port control?

[Rod Greene]

Thanks Vic, that's what I needed to know. 

By the way, I made a couple of QSOs with the rig yesterday on CW and think I have most of the controls working. I think the rig needs a good alignment. I downloaded that information from the Wiki, but that procedure calls for a 100 Mhz scope, which I do not have. So may have to look to someone else or Ten Tec to do an alignment in the future.

73, Rod/w7zrc
      From: Vic Klein via TenTec <tentec at contesting.com>
 To: tentec at contesting.com 
Cc: Vic Klein <vhklein at ptd.net>
 Sent: Tuesday, September 5, 2017 4:39 AM
 Subject: Re: [TenTec] Paragon 585 com port control?
   
The 585 Paragon used a unique set of control codes that were not generally
supported, but you can find the commands if you get the manual for the Model
258 RS-232 board which was an option on that radio. Do a Google search and
it should show up as a .pdf on qsl.net. I have one and, at the time, was
thrilled that the logging program I was already using, Hyperlog, supported
the Paragon for frequency and mode transfer. I wrote my own software for rig
control, basically as a way to easily save and retrieve the memories, and it
worked fine. Alas, both programs operated in DOS windows on my old XP
computer, but do not run in Win10, so I still have the old computer
connected to the Paragon, which is now a back-up rig, for any changes
needed.

 

The command structure is relatively straightforward, so you may be able to
make a template that will work with other more modern software. Note the
command structure changed on the Paragon 2 to be an Icom derivative, so it
is more widely supported, but it is not the same as on the 585.

 

73, =Vic=

WA4THR

----------------------------------------------------------------------------
-----------------------------


To: 

Discussion of Ten-Tec Equipment <tentec at contesting.com
<mailto:tentec%40contesting.com> >


Subject: 

Re: [TenTec] Paragon 585 com port control?


From: 

Rod Greene via TenTec <tentec at contesting.com
<mailto:tentec%40contesting.com> >


Reply-to: 

Rod Greene <w7zrc at yahoo.com <mailto:w7zrc%40yahoo.com> >, Discussion of
Ten-Tec Equipment <tentec at contesting.com <mailto:tentec%40contesting.com> >


Date: 

Mon, 4 Sep 2017 19:09:27 +0000 (UTC)


List-post: 

<mailto:tentec at contesting.com>


Thanks again for the thoughts (Hal).. I'm wondering what software will
control 

the Paragon via the com port? I checked HRD and N1MM+ and neither has
Paragon 

listed as transceivers in their lists for radio setup and connection.
Perhaps 

it would work with the Omni VI selection? I downloaded a manual copy but it 

doesn't contain any information about the command set for control. 

 

Thanks again and 73, Rod/w7zrc

                

 

_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec