[TenTec] OT: Question Connecting IC-7300 to AL-80A amplifier

[rick@dj0ip.de]

Please ignore post.

I finally found it on page 12.5 of the FULL User Manual.
It can be set to off (which is disastrous), and then 10 to 30mS in
increments of 5 mS.

For Ameritron Amplifiers without the QSK-5, it should be set to 25mS.

Sorry I Spammed the group.

73
Rick, DJ0IP

-----Original Message-----
From: TenTec [mailto:tentec-bounces at contesting.com] On Behalf Of
rick at dj0ip.de
Sent: Wednesday, September 20, 2017 5:52 PM
To: 'Discussion of Ten-Tec Equipment'
Subject: [TenTec] OT: Question Connecting IC-7300 to AL-80A amplifier

Hi guys and gals,

 

A friend of mine (also OM6 user) just purchased an IC-7300 and wants to run
it with his AL-80A (slow open-frame relay).

He asked me if the 7300 can be adjusted for proper CW amp keying timing.

 

I know that he will need:

..> About 25mS TXD (delay of RF after keying the Amp Key line)

..> About 200mS hang delay

 

I found in the manual how to adjust the hang delay but I can't find any
description of the default RF delay or TXD adjustment.

 

Anyone here been down that road yet?

 

Thanks.

 

73

Rick, DJ0IP

 

_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec