[TenTec] Omni VI+

[MadScientist1948]

If those are bad, I have some in one of my spare Omni 6 boards.

Gary

> On Apr 3, 2018, at 11:57 PM, Malcolm McLeman <f5vbu at cegetel.net> wrote:
> 
> Worst scenario is the T/R switching diodes on the BPF board.
> Take the top cover off then the speaker bracket at the back. Release coax lead 17 right hand back and inject a sig from antenna on there. 73 Malc F5VBU
> 
> On 4/3/2018 4:07 PM, Paul DeWitte wrote:
>> Good morning all, turned on my Omni VI+ this morning and I have no
>> receive audio of rf signals.
>> What I do have is atmospheric noise on all bands but no signals either
>> SSB or CW.
>> 
>> I have tried master reset twice. Checked for loose connections inside
>> with no luck.
>> 
>> I do have TX output.
>> 
>> Corsair II on same antennas work fine.
>> 
>> Any suggestions?
>> 
>> Thannks,73
>> Paul K9OT
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>> 
> 
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec