[TenTec] Omni VI+

[Malcolm McLeman]

The diodes re available on the open market though the type numbers on 
the board differ from the O-6 manual .. Malc

the board differ from the Omni VI cct diagram. Malc

On 4/4/2018 3:52 PM, MadScientist1948 wrote:
> If those are bad, I have some in one of my spare Omni 6 boards.
>
> Gary
>
>> On Apr 3, 2018, at 11:57 PM, Malcolm McLeman <f5vbu at cegetel.net> wrote:
>>
>> Worst scenario is the T/R switching diodes on the BPF board.
>> Take the top cover off then the speaker bracket at the back. Release coax lead 17 right hand back and inject a sig from antenna on there. 73 Malc F5VBU
>>
>> On 4/3/2018 4:07 PM, Paul DeWitte wrote:
>>> Good morning all, turned on my Omni VI+ this morning and I have no
>>> receive audio of rf signals.
>>> What I do have is atmospheric noise on all bands but no signals either
>>> SSB or CW.
>>>
>>> I have tried master reset twice. Checked for loose connections inside
>>> with no luck.
>>>
>>> I do have TX output.
>>>
>>> Corsair II on same antennas work fine.
>>>
>>> Any suggestions?
>>>
>>> Thannks,73
>>> Paul K9OT
>>> _______________________________________________
>>> TenTec mailing list
>>> TenTec at contesting.com
>>> http://lists.contesting.com/mailman/listinfo/tentec
>>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>