[TenTec] OmniVI rotary encoder

[Bob McGraw K4TAX]

Once you have the top and bottom covers off, remove the top screw on 
each side of the front panel.  The front panel will tilt forward for 
access to the encoder.

73

Bob, K4TAX



On 8/8/2018 4:14 AM, Steve Hunt wrote:
> Folks,
>
> I need to replace the rotary encoder in my OmniVI. Can anyone tell me 
> the easiest way to get at it and do the replacement. It's easy to spot 
> the encoder when you take the bottom cover off, but I wonder it you 
> then need to fully remove the front panel, and if so how big a job it is?
>
> Steve G3TXQ
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>