[TenTec] OmniVI rotary encoder

[Steve Hunt]

Bob,

Thanks - the new part should be with me by the weekend, so I'll give it 
a go then.

Steve G3TXQ

On 08/08/2018 14:28, Bob McGraw K4TAX wrote:
> Once you have the top and bottom covers off, remove the top screw on 
> each side of the front panel.  The front panel will tilt forward for 
> access to the encoder.
>
> 73
>
> Bob, K4TAX
>
>
>
> On 8/8/2018 4:14 AM, Steve Hunt wrote:
>> Folks,
>>
>> I need to replace the rotary encoder in my OmniVI. Can anyone tell me 
>> the easiest way to get at it and do the replacement. It's easy to 
>> spot the encoder when you take the bottom cover off, but I wonder it 
>> you then need to fully remove the front panel, and if so how big a 
>> job it is?
>>
>> Steve G3TXQ
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec