[TenTec] Winlink and Winmoor on an Omni 6 Plus

[Carl Moreschi]

It uses the Icom interface. Just select an Icom radio at the correct 
baud rate.

Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
www.n4py.com

On 3/2/2018 4:07 PM, Joe Papworth via TenTec wrote:
> Gents,
> Winmoor does not support the Omni 6 Plus in their Rig Control software.
> I'm thinking that someone once told me there was a different brand and model that used a command set equal to or very similar to the Omni 6.
> Does that ring any bells?
>
> Or, has anyone found another work-around for this problem?
>
> Thanks, Joe, K8MP
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec