[TenTec] Winlink and Winmoor on an Omni 6 Plus

[k8mp at aol.com]

Thanks Rod. I'll check it out.
Later, Joe, K8MP

Sent from AOL Mobile Mail


-----Original Message-----
From: Rod Greene via TenTec <tentec at contesting.com>
To: Discussion of Ten-Tec Equipment <tentec at contesting.com>
Cc: Rod Greene <w7zrc at yahoo.com>
Sent: Fri, Mar 2, 2018 05:34 PM
Subject: Re: [TenTec] Winlink and Winmoor on an Omni 6 Plus


Joe, seems like I used Icom 735 (some older version like that) with my Paragon that has an N4PY chip. The Omni 6 may be the same
GL es 73, Rod/w7zrc


      From: Joe Papworth via TenTec <<a href="mailto:tentec at contesting.com">tentec at contesting.com</a>>
 To: <a href="mailto:tentec at contesting.com">tentec at contesting.com</a> 
Cc: <a href="mailto:k8mp at aol.com">k8mp at aol.com</a>
 Sent: Friday, March 2, 2018 2:08 PM
 Subject: [TenTec] Winlink and Winmoor on an Omni 6 Plus
   
Gents,
Winmoor does not support the Omni 6 Plus in their Rig Control software.
I'm thinking that someone once told me there was a different brand and model that used a command set equal to or very similar to the Omni 6.
Does that ring any bells?

Or, has anyone found another work-around for this problem?

Thanks, Joe, K8MP



_______________________________________________
TenTec mailing list
<a href="mailto:TenTec at contesting.com">TenTec at contesting.com</a>
<a href="http://lists.contesting.com/mailman/listinfo/tentec" target="_blank">http://lists.contesting.com/mailman/listinfo/tentec</a>


 
_______________________________________________
TenTec mailing list
<a href="mailto:TenTec at contesting.com">TenTec at contesting.com</a>
<a href="http://lists.contesting.com/mailman/listinfo/tentec" target="_blank">http://lists.contesting.com/mailman/listinfo/tentec</a>