[TenTec] Pound sign (#) on Jupiter screen
Winston
jones_winston at bellsouth.net
Tue Nov 20 19:32:52 EST 2018
I just now went back on air with the Jupiter. The # disappears when I start tuning, then appears about 5 seconds after tuning stops. Changing other settings didn’t seem to affect it, although I tried only a few.
Again, no problems, just curious. I’ll see if I can find the manual reference.
73, Winston K4CWQ
Sent from my iPhone
> On Nov 20, 2018, at 7:18 PM, Mike Bryce <prosolar at sssnet.com> wrote:
>
> It’s in the manual, I can’t recall the actual page it’s on. but yup it means the radio’s current settings have been saved.
>
> mike, wb8vge
> “The trouble with quotes on the Internet is that you never know if they are genuine”
>
> —Abraham Lincoln
>
>> On Nov 20, 2018, at 6:53 PM, Winston <jones_winston at bellsouth.net> wrote:
>>
>> It’s not a whole bunch of #s, but a single one in the right corner. It doesn’t seem to cause any problems. I’m just curious. I could find no mention of it in the manual.
>> I suspect now, as suggested above, it means the settings have been recorded into memory.
>>
>> Winston K4CWQ
>>
>> Sent from my iPhone
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
More information about the TenTec
mailing list